Model: Interface IC
The shift register has a direct-overriding clear, serial input, and serial output (standard) pins for cascading. Both the shift register and storage register use positive-edge triggered clocks. If both clocks are connected together, the shift register state will always be one clock pulse ahead of th..
Rs.12
Model: Interface IC
The AD694 is the ideal building block for systems requiring noise immune 4–20 mA signal transmission to operate valves, actuators, and other control devices, as well as for the transmission of process parameters such as pressure, temperature, or flow. It is recommended as a replacement for discrete ..
Rs.987
Model: IC
CH340 is a series of USB bus adapters,
that provides serial, parallel or IrDA interfaces over the USB bus (note:
CH340G supports serial interface only). The CH340G integrate circuit provides
common MODEM signals to allow adding a UART to a computer or converting
existing UART devices to USB inte..
Rs.68
Model: IC
The CP2102 USB to UART
Bridge provides a complete plug and play interface solution that includes
royalty-free drivers. This USB 2.0 compliant device includes 0 digital I/O pins
and is availble in a 5x5 mm QFN28 package.
Features:-
Integrated USB transceiver; no
external res..
Rs.150
Model: IC
The DS1232 Micro Monitor™ Chip monitors three vital conditions for a
microprocessor: power supply, software execution, and external override. First,
a precision temperature-compensated reference and comparator circuit monitors
the status of VCC. When an out-of-tolerance condition occurs, an inter..
Rs.75
Model: IC
The DS75176B is a high speed
differential TRI- [email protected]/line transceiver designed to meet the requirements
of EIA standard RS485 with extended common mode range (+12V to —7V), for
multipoint data transmission. In addition, it is compatible with RS-422. The
driver and receiver outputs feature TR..
Rs.45
Model: IC
The DS8921 device are
differential line driver and receiver pairs designed specifically for
applications meeting the ST506, ST412, and ESDI disk drive standards. In
addition, these devices meet the requirements of the EIA standard RS-422.The DS8921x receivers
offer an input sensitivity of 200 mV..
Rs.155
Model: IC
The FAN7392 is a
rnonolithic high- and low-sde gate drive IC that can drive high-speed MOSFETs
and IGBTs that operate up to +600V. It has a buffered output stage with all
NMOS transistors designed for high pulse current driving capability and minimum
cross-conduction. Fairch- ild's high-voltage ..
Rs.79
Model: IC
The FT245RL is a USB to parallel FIFO
interface with the following advanced features:-
Single chip USB to parallel FIFO
bidirectional data transfer interface.
Entire USB protocol handled on the
chip. No USB specific firmware programming required.
Fully integrated 1024 bit EE..
Rs.659
Model: IC
The ICL7107 is a high performance, low power, 31/2
digit A/D converters. Included are seven segment decoders, display drivers, a
reference, and a clock. The ICL7107 will directly drive an instrument size
light emitting diode (LED) display. The ICL7107 bring together a combination of
high accurac..
Rs.105
Model: IC
The ICL7135 precision A/D
converter, with its multiplexed BCD output and digit drivers, combines
dual-slope conversion reliability with ±1 in 20,000 count accuracy and is
ideally suited for the visual display DVM/DPM market. The 2.0000 Volt full
scale capability, auto-zero, and auto-polarity are..
Rs.220
Model: IC
The IR2101 is high voltage, high speed
power MOSFET and IGBT driver with independent high and low side referenced
output channels. Proprietary HVIC and latch immune CMOS technologies enable
ruggedized monolithic construction. The logic input is compatible with standard
CMOS or LSTTL output, down..
Rs.139